EyezOn Forum

Hello,

Just got my InvisaLink 4 delivered today and connected it up. The KeyB light keeps flashing indicating that there's a connection/communication problem with the module and the security panel. I have a Honeywell WA3000 Rev 9.12 (Vista 20P).

Photo: https://i.imgur.com/Um31kHX.jpg

I tested the continuity between the screws on the panel, and the bottom side of the PCB with a multimeter, so it is definitely connected.

I installed the InvisaLink 4 Module connected while having the AC power, and battery disconnected. I then reconnected the battery and then the AC power.

I can connect to the module just fine over my LAN. It says that there's no client connected: https://i.imgur.com/cTjASLv.png

If the KEYB LED is flashing that means you installed DSC firmware, not HONEYWELL firmware.

Delete the module from your EyezON account from the settings tab. Then re-activate the module but remember to select Envisalink 4 HONEYWELL, not DSC.

GrandWizard wrote:If the KEYB LED is flashing that means you installed DSC firmware, not HONEYWELL firmware.

Delete the module from your EyezON account from the settings tab. Then re-activate the module but remember to select Envisalink 4 HONEYWELL, not DSC.

This was the answer!