Motion events from SOME sensors not being logged
Posted: Thu Jan 27, 2022 3:56 pm
Hi - I have a few different motion sense zones in system. One of them, Zone 2 happily reports motion every time there is any in the eyezon interface. For the other two, the motion sensors “work” (red light turns on) but there isn’t any corresponding notification in the eyezon status monitor interface.
- Zone 2 - Kitchen (IS52535), zone type 4, report code 20
- Zone 6 - Garage (IS2500LT), zone type 2, report code 60
- Zone 24 - Remote room motion, zone type 2 report code 80
This is a single partition setup, all on partition 1.
I’m definitely a security system novice but an avid do-it-myselfer who loves the eyezon system…. I suspect there may be some flag in the alarm panel setup that has the other two motion sensors quiet? Or some sort of report code adjustment i need to make?
The panel is a Vista 128BPT.
- Zone 2 - Kitchen (IS52535), zone type 4, report code 20
- Zone 6 - Garage (IS2500LT), zone type 2, report code 60
- Zone 24 - Remote room motion, zone type 2 report code 80
This is a single partition setup, all on partition 1.
I’m definitely a security system novice but an avid do-it-myselfer who loves the eyezon system…. I suspect there may be some flag in the alarm panel setup that has the other two motion sensors quiet? Or some sort of report code adjustment i need to make?
The panel is a Vista 128BPT.