EyezOn Forum

Hi,

I have the DSC alarm system and it has auto arm/disarm enabled. At times I want to disable the auto arm/disarm remotely via Eyezon Command Custom Sequence.

The sequence for the keypad is:
*6 <user code> 2

At the Eyezon Command Custom sequence I tried to issue the following but it didn't work:
presuming the user code is 9999
*69992

Any idea what was wrong?

Other than the trailing #, that should work.

*69992#

Remember, this is a TOGGLE. So if you send it twice, you just go back to what you had.

Cool. Thank you very much for the tips. Appreciate it.