EyezOn Forum

i've had the evl3 installed in my dsc1864 panel case for quite a few years now and it has worked fine...but only with the top two standoffs in place (so the board wobbles a bit when pushed on).

recently i've added the alula bat connect, and it's driving me nuts that the board is in there flapping around without the third standoff installed. so, i'm planning on pulling the panel down, drilling a third hole and putting in the third standoff. unfortunately though, i don't have the standoff that came with it and don't know which one to buy.

can anyone tell me which standoffs to buy that will match the two that i installed with the panel so many years ago?

They are pretty standard. Here is the DigiKey part number from Richco.


RPC1126-ND

GrandWizard wrote: ↑Sun Jan 26, 2025 1:18 pm They are pretty standard. Here is the DigiKey part number from Richco.


RPC1126-ND

thanks. would these 10mm work?

https://www.amazon.com/Support-Standoff ... XddF3&th=1

i can get a 50 pack of those for $7 shipped and they'll be here tomorrow, vs paying $8 for two basically after shipping from digikey and having to wait a week for them to come in. 10mm is slightly larger than the ones you mentioned but pretty close.

I'm sure you can shave them down if too big. The ends that go into the PCBs should be fine as they flex.

Digikey has overnight shipping for $8 flat, incredible service. I can put an order in at 4PM and have them on my doorstep by noon the next day, many times before I leave for work.