EyezOn Forum

Hi,

I just ordered my EVL-3 and I've looked and the install video on youtube and it looks very straightforward. I did have some questions that I was not sure about. Is it required to completely shutdown the entire alarm system to install the EVL? I don't know of he proper procedure to shutdown the system, is it a matter of disconnecting the battery and pulling the plug? Is there anything I need to do on the panel prior to shutting down? thanks

Kevin

You should always shutoff power to a panel before you add any new hardware. And you were correct, unplug battery then unplug transformer install EVL3 then plug battery back in then plug in transformer.

Thank you smyers! cant wait to get this setup.

Hi,

So I just installed everything and it went without a hitch. One thing I cannot figure out is how do I arm the alarm in stay mode ? When I arm it with the code it goes into away mode.

I have a honeywell system, when I click arm it asks me if I want to ARM stay, away, or instant then I put in my code.