EyezOn Forum

Wondering if this is possible by following the factory reset of the Envisalink in the FAQ or does the module have to replaced with a new Envisalink when moving to another panel? Anything that may go wrong with this? Thanks

Finally talked yourself into switching systems? I would asume a factory reset would make it as ready as one from the factory. Good luck with the transfer and be careful with the factory reset.

No, it is not a "factory" reset, just a reset of local programming. But, if you delete your module from your Eyezon account and then create a new one but designate it as a DSC system, it will know enough to go and download the proper firmware for itself. It can switch genders on the fly, so to speak.

So in the end, yes, you can easily do this.

Yea Smyers I think I am just going to go ahead and try the DSC. At this point I am not really invested at all in the Vista so I am going to try the DSC and see how it works. GrandWizard thanks, so do I even need to perform the reset? It sounds like all I got to do is just delete it from the eyeson account and than re-install again specifying it as a DSC? Any downside of this process? I can just return this one and get another one since I have had it for only a week. What do you think is the best course of action?

You can switch back and forth between DSC and Ademco firmware without issue. The only downside is that you will lose any events that are already in your log. This would apply to replacing the module as well.

Ok so is it nec to perform the factory reset?

No, it is not necessary. The reset is really just to save you if you made your module static and couldn't access it.