Are these commands actually implemented yet?
Posted: Fri Apr 19, 2013 4:49 am
I've never seen the Envisalink3 respond with the following commands yet :
900(code required), 912 (command output pressed), 921(master code required), 922 (installer code required)
Furthermore at least some of these commands seem duplicated by the 200 (code send) command.
It's really not clear from the docs how or when we can expect these to be sent, or even why (it seems to be just informational).
Has anyone ever seen these codes sent by the module, or is there an example of what sequence of events would cause these codes to be sent?
For example sending key codes to program a bypass SHOULD prompt for a code - but nothing is requested (we have to include the code in the keystroke sequence).
If I understand it correctly, we should receive a 921, and respond with a 200+relevant code?
Perhaps it's just something specific to my pc1864 module.
many thanks
wh
900(code required), 912 (command output pressed), 921(master code required), 922 (installer code required)
Furthermore at least some of these commands seem duplicated by the 200 (code send) command.
It's really not clear from the docs how or when we can expect these to be sent, or even why (it seems to be just informational).
Has anyone ever seen these codes sent by the module, or is there an example of what sequence of events would cause these codes to be sent?
For example sending key codes to program a bypass SHOULD prompt for a code - but nothing is requested (we have to include the code in the keystroke sequence).
If I understand it correctly, we should receive a 921, and respond with a 200+relevant code?
Perhaps it's just something specific to my pc1864 module.
many thanks
wh