Custom Zone Reportig

[DeanRobinson]

On my vista 20P Version 9.12 I have a wireless zone "RF" setup as a perimeter zone using a "Custom Zone" the alarm and sensor seems to work completely normal, I set the alarm wait for the exit time then I open that window the alarm goes off the keypad shows the zone breached then my pot's lines calls my cell, However I never get any message from the Envisalink, Plus I noticed that the Envisalink will not show any other condition "a door was also opened" until I cleared the fault off the keypad. On the custom zone I do get a text when I set it as a zone follower so I know Envisalink is aware of the sensor.
Here is my string I am using for the Custom RF zone: 0 11 0 1 0 1 0 0 6 6 Is there something I am putting in wrong as far as the Envisalink goes. Does Envisalink support RF zones with custom zones? Keep in mind the alarm it self works normal.

One last note as a test I left the report codes alone just change the zone type from custom to a standard perimeter and Envisalink did report that.

Any help would be appreciated. I hope all this make sense. Or should I submit this to the Tech. Dept.

Dean

[DeanRobinson]

Well I might have figured it out. I believe that since I am using a "Custom Zone" AND I am outside the spectrum of using the Keypad when programming custom zones #92 And #93, I have to use Ademco software "Compass" and a modem to dial into the panel. What I did was add in a "Alarm CID Code of 130" I assume this field not automatically selected when using the custom zone configuration.

So for now I believe my problem is solved. I will keep everyone posted if see any other issue's or solutions.

Thanks!
Dean