Programming PC1555MZ for Dummies for Envisalink
Posted: Sun Aug 04, 2013 5:21 pm
Hello,
I recently purchased a house with a PC1555MX system installed. The installer code was not obvious so I had to reset the system. The keypad is a 1555RKZ. I also purchased an Envisalink 2DS off of ebay to enable notifications.
How I have a few questions.
1) I read the installation manual regarding programming, but I am somewhat lost in what I actually need to program. I have six zones with door and window contacts. Is there additional how-to guides to interpreting the language of the manual?
2) I would like to add some wireless sensors in the future to add keyfobs and motion sensors. What would be involved in adding them?
3) I tried to active the Envisalink that I bought used, but I get the following error message ‘The Device is Already Activated On Our System or is an Invalid MAC. If You Continue To Experience Problems Please Contact Us For Assistance’ Is it possible to active a used system.
4) Do you know if you can program a PC1555 with the envisalink or would it make sense for me to make a computer interface cable and find the programming software?
I recently purchased a house with a PC1555MX system installed. The installer code was not obvious so I had to reset the system. The keypad is a 1555RKZ. I also purchased an Envisalink 2DS off of ebay to enable notifications.
How I have a few questions.
1) I read the installation manual regarding programming, but I am somewhat lost in what I actually need to program. I have six zones with door and window contacts. Is there additional how-to guides to interpreting the language of the manual?
2) I would like to add some wireless sensors in the future to add keyfobs and motion sensors. What would be involved in adding them?
3) I tried to active the Envisalink that I bought used, but I get the following error message ‘The Device is Already Activated On Our System or is an Invalid MAC. If You Continue To Experience Problems Please Contact Us For Assistance’ Is it possible to active a used system.
4) Do you know if you can program a PC1555 with the envisalink or would it make sense for me to make a computer interface cable and find the programming software?