EyezOn Forum

Hi

I have an EVL-3 connected to my DSC PC 1864, and most of it works ok.

The only problem is that in the EVL own web page 2 zones have a status of "CLOSED 0 seconds ago" and the counter never goes up.

The DSC keypad shows the correct status.

Is this a firmware issue?

Thanks

Update: I checked through the command line interface, via telnet:

- The sensor is physically CLOSED.
- The Keypad shows it closed
- Command 001 shows it OPEN
- Command 008 shows counter as FFFF (0 seconds)

Data shown for all other sensors is correct.

Any idea on how to solve this will be much appreciated.

Request a support ticket.