Page 1 of 1
Zone open
Posted: Fri Oct 31, 2014 10:10 am
by e50golf
I have a DSC 1632 alarm system with an envisalink module installed. When accessing the module through eyezon, it shows that zone 2 is open. The alarm works fine and the zones are all closed. What can cause this problem?
Re: Zone open
Posted: Wed Dec 24, 2014 11:53 am
by gmyers
I am having the same issue. Any suggestions?
Re: Zone open
Posted: Wed Dec 24, 2014 12:51 pm
by GrandWizard
In all cases it was either that the zone was no programmed properly in the panel, or a misunderstanding of zone colouring.
http://forum.eyez-on.com/FORUM/viewtopic.php?f=11&t=439
If you still have issues submit a support request as we will need more information than you can provide in public.