EyezOn Forum

I have a Vista 20p that I am running wireless. The door contact zones report an alarm when triggered. However, while in Away, while the motion detector does set the alarm off (in an instant), it does not seem to be reporting back up to the monitoring. I did use the same reporting code for all zones. I have them set up as interior follower type 04. Any ideas? Thanks in advance.

On the events it says ""Exit Fault" rather than an "alarm".

Exit Fault is a type of false alarm. It means the alarm was tripped shortly after being armed (closed) and therefore is probably someone not closing the door properly. If a monitoring station receives and Exit Fault, they are usually ignored.

Try arming your system and waiting 5 minutes before you trip it.