Page 1 of 1

Feel like an idiot... EVL-3

Posted: Thu Nov 19, 2015 7:49 pm
by dbecks
So I moved into a house that had an EVL three and re-registered it to my account. I have access to it but am lost at how to program commands. When I pull up available commands it only shows PGM, Zone, Sequence and Send reset, no arm, no disarm. I am pretty lost and tried to figure it out. Am I missing something?

Re: Feel like an idiot... EVL-3

Posted: Fri Nov 20, 2015 12:06 pm
by Cobra
Are you using the eyezon web interface to issue the commands?

Re: Feel like an idiot... EVL-3

Posted: Fri Nov 20, 2015 1:12 pm
by GrandWizard
I would start with reading the manual for your panel first. Understand it's behaviour and then you will understand the Envisalink easier. You won't see an ARM command option if your partition isn't ready. This means that all zones have to be secured.