EyezOn Forum

Does anyone have mechanical dimensions for the PCB so I can waterjet myself a board mount?

edit: Using my camera, I was able to come up with rough dimensions, see attached. Dims are in mm.
Let me know if anyone can confirm these numbers.

The upper two holes are parallel to each other. From my measurements the vertical distance (y) from the bottom hole to the top two is 25.50mm.

The distance from right-most hole to the next left hole, in the x direction, is 6.98mm.

and the x distance from the right-most hole to the left-most hole is 62.86mm

and I have access to some pretty precise drawings